Cognitivetpg A799 Uživatelský manuál stáhnout pdf (Strana 5)

TPG-ETHSUG Rev. A 11/07

Ethernet Interface Setup Guide

Ethernet setup commands

The following commands are designed to set the required printer internal parameters for Ethernet operation. The

commands can only be used in the Flash download (boot) mode.

Restore default settings

ASCII US BS NUL

Hexadecimal 1F 08 00

Decimal 31 8 0

Restores the Ethernet settings to the preset values.

Default settings are:

IP address: 192.0.0.192 (in use after boot time-out of two minutes)

Net mask: 0.0.0.0 (default mask of selected IP is used)

Gateway: none

Raw TCP/IP port 9001: active

Telnet Daemon: enabled

LP Daemon: disabled

Bootp: disabled

DHCP: enabled

Inactivity timeout: enabled

Keep alive pings: disabled

Setting IP address

ASCII US BS SOH n1 n2 n3 n4

Hexadecimal 1F 08 01 n1 n2 n3 n4

Decimal 31 8 1 n1 n2 n3 n4

Default: 192.0.0.192

Sets the IP address value specied by the values of n1 to n4.

Setting Net Mask

ASCII US BS STX n1 n2 n3 n4

Hexadecimal 1F 08 02 n1 n2 n3 n4

Decimal 31 8 2 n1 n2 n3 n4

Default: 0.0.0.0

Sets the Net Mask value specied by the values n1 to n4.

Setting the Gateway

ASCII US BS ETX n1 n2 n3 n4

Hexadecimal 1F 08 03 n1 n2 n3 n4

Decimal 31 8 3 n1 n2 n3 n4

Default: none

Sets the printer to the gateway having the IP address value specied by the values n1 to n4. A gateway, even when the

printer is on another subnet, is not always needed.

The printer initiates no connection and obtains the gateway address from the host packets. Image units must have the

gateway specied to act as client when sending images to hosts on another subnet.

1 2 3 4 5 6 7 8 9 10

Žádné komentáře

Cognitivetpg A799 Uživatelský manuál Strana 5